The short answer
Measure visible lag before changing transport or encoding. A lower bitrate helps only if it preserves necessary motion detail and the source itself is current.
Work through the checks
Show a visible changing clock or a supervised movement in the camera scene, then compare it with the live image. Use the same source and layout for each latency comparison.
Compare with a wired connection where practical, keeping the stream profile unchanged. This separates Wi-Fi signal or contention problems from camera encoding and viewer behavior.
If the viewer exposes transport selection, compare TCP and UDP on the same local route. TCP can avoid UDP loss but may accumulate delay; record visible gaps and end-to-end lag.
Lower one camera parameter at a time: frame rate, resolution or bitrate. Re-test motion and readable detail; a lower idle bitrate alone does not prove a usable moving image.
What to verify
Observe CPU, GPU, memory and network use in Windows Task Manager with one view, then add views gradually. Record the point where playback begins to lag.
Sources and scope
AeoCam is available for Windows. Camera settings below describe protocol preparation, not a certification of a particular camera or a promise of every feature in every app version. Check the installed build and the Microsoft Store listing for current availability.
Vendor documents describe the camera or protocol. No physical-camera compatibility test is claimed here. Menus and capabilities can change with model and firmware.