The short answer
Check the restored network route and camera session after wake. Compare a clean reconnect with the pre-sleep state before changing the camera’s permanent configuration.
Work through the checks
Distinguish screen-off from computer sleep. A computer that sleeps may stop local processing even while the camera stays powered; test the intended power state and reconnect behavior.
Check which Ethernet, Wi-Fi or VPN adapter owns the route to the camera. Test a single known route before changing adapter priority or network policy.
Read the camera address in your router’s DHCP client list or the manufacturer’s local setup tool. Confirm the entry against the MAC address instead of guessing an address.
Change one setting, then repeat the same short test after a controlled app or device restart. Record the error time and whether the problem recurs rather than treating a temporary recovery as a diagnosis.
What to verify
Test one camera and one stream before opening a larger camera wall. Keep the camera settings unchanged while you establish whether the first live image is stable.
Sources and scope
AeoCam is available for Windows. Camera settings below describe protocol preparation, not a certification of a particular camera or a promise of every feature in every app version. Check the installed build and the Microsoft Store listing for current availability.
Vendor documents describe the camera or protocol. No physical-camera compatibility test is claimed here. Menus and capabilities can change with model and firmware.